3D-printed frame

Put Fusion 360 files (.f3d) here and exported print files in stl/.

Name prints by version so you can tell them apart: frame_v1_fit.stl, frame_v2.stl, cam_wedge_25deg.stl.

Design notes

• Camera board (27 x 40.5 mm) on the outside of one arm, just behind the hinge, lens forward.
• Battery, TP4056 and MT3608 in the other arm so the glasses balance.
• Camera mount angled 20-30 degrees down; swappable wedges at 15, 25, 35 degrees.
• TP4056 Type-C port at the back end of the battery arm.
• Wire channel along the top of the front bar (5V and GND).
• Button on the camera arm; slide switch under the battery arm.
• Vent slots near the ESP32-CAM.
• PETG preferred, PLA OK. Fixed arms, no hinges.

Measurements (fill in Monday)

Print log